Simple Module EtherMacVlan

Package: Vlans.linklayer
File: src/linklayer/EtherMacVlan.ned

C++ definition

TODO auto-generated module

Usage diagram:

The following diagram shows usage relationships between types. Unresolved types are missing from the diagram.

Inheritance diagram:

The following diagram shows inheritance relationships for this type. Unresolved types are missing from the diagram.

Used in compound modules:

If a module type shows up more than once, that means it has been defined in more than one NED file.

EtherVlanInterface (compound module)

TODO auto-generated module

Parameters:

Name	Type	Default value	Description
promiscuous	bool	true	ALWAYS TRUE... LLC Will take care...
address	string	"auto"	MAC address as hex string (12 hex digits), or "auto". "auto" values will be replaced by a generated MAC address in init stage 0.
txrate	double	100Mbps	maximum data rate supported by this station (bit/s); actually chosen speed may be lower due to auto- configuration. 0 means fully auto-configured.
duplexEnabled	bool	true	whether duplex mode can be enabled or not; whether MAC will actually use duplex mode depends on the result of the auto-configuration process (duplex is only possible with DTE-to-DTE connection).
txQueueLimit	int	1000	maximum number of frames queued up for transmission; additional frames are dropped. Only used if queueModule==""
queueModule	string	""	name of optional external queue module
mtu	int	1500

Properties:

Name	Value	Description
display	i=block/rxtx

Gates:

Name	Direction	Description
upperLayerIn	input	to EtherLLC or MACRelayUnitPP
upperLayerOut	output	to EtherLLC or MACRelayUnitPP
phys	inout	to physical layer or the network

Source code:

//
// TODO auto-generated module
//
simple EtherMacVlan
{
    parameters:

        @display("i=block/rxtx");

        bool promiscuous = default(true); // ALWAYS TRUE... LLC Will take care...
        string address = default("auto");  // MAC address as hex string (12 hex digits), or
                                // "auto". "auto" values will be replaced by
                                // a generated MAC address in init stage 0.
        double txrate @unit("bps") = default(100Mbps); // maximum data rate supported by this station (bit/s);
                                // actually chosen speed may be lower due to auto-
                                // configuration. 0 means fully auto-configured.
        bool duplexEnabled = default(true);   // whether duplex mode can be enabled or not; whether
                                // MAC will actually use duplex mode depends on the result
                                // of the auto-configuration process (duplex is only
                                // possible with DTE-to-DTE connection).
        int txQueueLimit = default(1000); // maximum number of frames queued up for transmission;
                                // additional frames are dropped. Only used if queueModule==""
        string queueModule = default("");    // name of optional external queue module
        int mtu = default(1500);

    gates:
        input upperLayerIn;    // to EtherLLC or MACRelayUnitPP
        output upperLayerOut;  // to EtherLLC or MACRelayUnitPP
        inout phys @labels(ether); // to physical layer or the network
}